The following text may have been generated by Optical Character Recognition, with varying degrees of accuracy. Reader beware!

THOMPSON'S COAST PILOT. 193 Cuass 5. Vessels of which the tonnage length, according to the above measurement, is above two hundred feet, and not exceeding two hundred and fifty feet long, into fourteen equal parts. Crass 6. Vessels of which the tonnage length, according to the above measurement, is above two hundred and fifty feet long, into sixteen equal parts. METHOD OF FINDING THE AREAS, TRANSVERSE AREAS.--Then, the hold being sufficiently cleared to admit of the required depths and breadths being properly taken, find the trans- verse area of such vessel at each point of division of the length as fol- lows: Measure the depth at each point of division from a point at a dis- tance of one-third of the round of the beam below such deck; or, in case of a break, below a line stretched in continuation thereof, to the upper side of the floor-timber, at the inside of the limber-strake, after deducting the average thickness of the ceiling, which is between the bilge-planks and limber-strake ; then, if the depth at the midship division of the length does not exceed sixteen feet, divide each depth.into four equal parts; then measure the inside horizontal breadth, at each of the three points of divi- sion, and also at the upper and lower points of the depth, extending each measurement to the average thickness of that part of the ceiling which is between the points of measurement; number these breadths frorn above (numbering the upper breadth one, and so on down to the*lowest breadth); multiply the second and fourth by four, and the third by two; add these products together, and to the sum add the first. breadth and the last, or fifth ; multiply the quantity thus obtained by one-third of the common interval between the breadths, and the product shall be deemed the trans- verse area; but if the midship depth exceed sixteen feet, divide each depth into six equal parts, instead of four, and measure, as before directed, the horizontal breadth at the five points of division, and also at the upper and lower points of the depth; number them from above as before; multiply | the second, fourth and sixth by four, and the third and fifth by two; add these products together, and to the sum add the first breadth and the last, or seventh; multiply the quantities thus obtained by one-third of the common interval between the breadths, and the product shall be deemed the transverse area. METHOD OF ASCERTAINING THE REGISTER TONNAGE OF VESSEL. CoMPUTATION FROM AREAS.--Having thus ascertained the transverse area at each point of division of the length of the vessel, as required above, proceed to ascertain the' register tonnage of the vessel in the fol- lowing manner: Number the areas successively, one, two, three, etc., num- ber one being at the extreme limit of the length at the bow, and the last number at the extreme limit of the length at the stern; then, whether the RE Te LON NIE RE DE SM Ne LT POE